Power Window Switch - Installation

INSTALLATION

FRONT SWITCH MODULE





1. Position the front door switch module (1) close enough to the mounting hole in the arm rest (2) of the front door trim panel to access and reconnect the front door wire harness connector (3) to the switch connector receptacle.
2. Align the switch module to the arm rest mounting hole.
3. Using hand pressure, press the switch module firmly and evenly into the mounting hole until the four spring steel retainers of the switch are fully engaged and the switch bezel is fully seated against the arm rest.
4. Connect the battery negative cable.

REAR SWITCH ASSEMBLY

NOTE: Some interior trim packages may make switch removal difficult by traditional means, and require interior trim panel removal to service the switch assembly.





1. Install the switch (1) in the trim panel engaging the four clips (2) that secure the switch.
2. Position the trim panel close enough to the door and connect the electrical connector.
3. Install the rear door interior trim panel, Rear Door Trim Panel - Installation.