Electronically Controlled Clutch - Removal

REMOVAL

NOTE: NOTE: Rubber coupler is part of the propeller shaft assembly. Removing coupler from propeller shaft will result in vibration/balance issues.





1. Make sure transaxle is in neutral (N).
2. Raise vehicle on hoist.
3. Apply alignment index marks (4) on the rear axle flange (5) and rubber coupler (1).
4. Remove three rear propeller shaft rubber coupler to rear axle input flange retaining bolts (3).
5. Slide propeller shaft (2) back off rear axle input flange (5) and move out of the way as needed.





6. Unplug the electrical connector at the ECC.
7. Remove the mounting bolts at the ECC.
8. Remove the ECC.