Vanity Lamp - Installation

INSTALLATION

CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket or the lamp wiring.

NOTE: Vehicles equipped with optional vanity lamps have a lamp on each side of a covered mirror that is integral to each sun visor. Both lamps are controlled by an integral switch that is automatically actuated by the mirror cover. The bulb types and service procedures are identical for both of these lamps.





1. Align the ends of the bulb (3) with the two bulb holders within the vanity lamp housing.
2. Carefully press the bulb firmly and evenly into the bulb holders until it snaps into place.
3. Engage the tabs on the inboard edge of the lens (2) within the lamp housing.
4. Using hand pressure, press the outboard edge of the lens over the lamp housing until the two tabs (1) at the outboard edge of the lens snap into place.
5. Reconnect the battery negative cable.