Brake Master Cylinder Reservoir - Removal

REMOVAL

CAUTION: If at any time the master cylinder is loosened or removed, you must perform the master cylinder installation procedure to ensure that the seal (o-ring) is still on the hub of the master cylinder Brake Master Cylinder - Installation .

NOTE: The brake fluid level switch is mounted through the center of the fluid reservoir. The switch can be serviced separately from the master cylinder fluid reservoir Brake Fluid Level Switch - Removal

NOTE: Before proceeding, Warning Brakes - Caution .





1. Remove the outer and inner cowl covers Service and Repair
2. Remove the front wiper motor module Wiper Arm Linkage - Removal
3. Clean the master cylinder housing and brake fluid reservoir. Use only Mopar(R) Brake Parts Cleaner or equivalent.
4. Remove the wiring harness connector (1) from the brake fluid level switch (2) in the master cylinder brake fluid reservoir.
5. Remove the brake fluid reservoir cap. Using a syringe or equivalent type tool, empty as much brake fluid as possible from the reservoir.





6. Remove the four reservoir retaining tabs from the mounting posts on the master cylinder housing.
7. Pull the reservoir straight up and remove it from the grommet seals in master cylinder housing.