Rear Fog Lamp - Removal

LAMP

NOTE: The following procedure applies only to vehicles manufactured for certain export markets where rear fog lamps are optional or required equipment. In North American markets, a rear reflex (reflector) is installed in each rear fascia opening used for the rear fog lamps, but rear fog lamps are not available in vehicles manufactured for North American markets.





1. Disconnect and isolate the battery negative cable.
2. Using a trim stick or another suitable wide flat-bladed tool, gently pry the inboard edge of the rear fog lamp housing (2) out from the rear bumper fascia (1) far enough to disengage the snap feature integral to the inboard side of the lamp housing from the rear fascia opening.
3. Pull the lamp housing slightly inboard to disengage the retention feature integral to the outboard side of the lamp housing from the rear fascia opening.
4. Pull the lamp away from the rear fascia opening far enough to access and disconnect the rear fascia wire harness connector from the lamp socket on the back of the lamp housing.
5. Remove the lamp from the back of the rear fascia.