Installation

INSTALLATION





1. Install the wiring harness onto the transaxle.
2. Connect the input speed sensor connector.
3. Connect both output speed sensor connectors (1, 2).





4. Connect the solenoid/pressure switch assembly connector (2).






NOTE: The two transaxle-to-engine bolts next to the inspection cover will have a exhaust bracket under them.

5. Install transaxle into position. Install the transaxle-to-engine two outer lower bolts and torque to 70 Nm 52 ft. lbs.).
6. Install torque converter-to-driveplate bolts (1) and tighten to 88 Nm (65 ft. lbs.).





7. Install torque converter dust shield and bolt tighten to 6 Nm (53 in. lbs.).





8. Install the bolts (2) to stand off bracket (4) and tighten to 95 Nm (70 ft. lbs.).
9. Install the bolts (3) to exhaust bracket.
10. Install the cross under pipe . Exhaust Crossunder Pipe - Installation










11. Install the starter motor Starter - Installation.
12. Install the power takeoff unit, if equipped.





13. Install the front mount bracket (2).
14. Install the front mount bracket bolts (1) and tighten to 100 Nm (74 ft. lbs.).





15. Install the transmission crossmember and tighten to 50 Nm (37 ft. lbs.).





16. Install the front mount through bolt and tighten to 50 Nm (37 ft. lbs.)
17. Install the front and both side splash shields Splash Shield - Installation.





18. Lower the vehicle.
19. Install the left side mount bolts and tighten to 100 Nm (74 ft. lbs.).





20. Install the rear mount and bolts, tighten to 100 Nm (74 ft. lbs.).





21. Install the bolt (2) holding the ground cable (3) to the front mount bracket (1) and tighten to 50 Nm (37 ft. lbs.).
.




22. Install the transaxle-to-engine upper bolts and tighten to 70 Nm (52 ft. lbs.).
23. Install halfshaft assemblies Half Shaft - Installation.





24. Install the crankshaft position sensor (1) and tighten bolt to 12 Nm (105 in. lbs.).
25. Connect the electrical connector to the crankshaft position sensor.
26. Connect the transmission cooler lines to the transaxle Service and Repair.





27. Connect the gearshift cable to the bracket.
28. Connect gearshift cable to the transaxle manual valve lever. Verify adjustment.





29. Connect the powertrain control module electrical connector.





30. Install the air cleaner housing (3) and the engine cover.





31. Connect the intake air temperature sensor electrical connector (1).
32. Connect the negative battery cable.