Erasing Homelink(R) Transceiver Codes

ERASING HOMELINK(R) TRANSCEIVER CODES

NOTE: Individual channels cannot be erased. Erasing the HomeLink(R) transceiver codes will erase ALL programmed codes.

Erasing Homelink(R) Transceiver Codes (Electronic Vehicle Information Center (EVIC) Equipped Vehicles.

To erase programming from all three buttons (individual buttons cannot be erased but can be "reprogrammed"), follow the step noted:

- Press and hold the two outer HomeLink(R) transceiver buttons until the EVIC displays "CLEARING CHANNELS" , do not release the buttons until "CHANNELS CLEARED" is displayed on the EVIC (after approximately 20 seconds). Release both buttons. Do not hold for longer that 30 seconds. HomeLink(R) is now in the train (or learning) mode and can be programmed at any time beginning with "Programming" , Programming Homelink(R) Transceiver Codes.