Installation

4X4










1. Install the brake dust shield (2).
2. Install the hub/bearing (1) into the steering knuckle (3) and tighten the bolts to specifications Front Suspension Specifications.

3. Install the brake rotor and caliper Brake Rotor - Installation.
4. Install the ABS wheel speed sensor if equipped Front.
5. Install the upper ball joint nut to the steering knuckle and tighten to specifications Front Suspension Specifications.
6. Install the tie rod end nut to the steering knuckle and tighten to specifications Front Suspension Specifications.
7. Install the halfshaft nut and tighten to specifications Front Suspension Specifications.
8. Install the wheel and tire assembly Service and Repair.
9. Remove the support and lower vehicle.