Radio - Removal

REMOVAL

NOTE: For REQ radios, turn ignition to RUN and press the SET + SCAN buttons simultaneously to place the radio into transportation mode. The radio will display "Transportation" on the display within 5 seconds. If the radio is inoperative or not REQ, skip this step.






CAUTION: Pulling the antenna cable straight out of the radio without pulling on the locking antenna connector could damage the cable or radio.

1. Pull the radio out far enough to access the back of the radio.
2. Disconnect the AM/FM antenna (2) and electrical connectors (1).
3. If equipped, disconnect the navigation antenna (3).
4. If equipped, disconnect the USB connectors (4).
5. Remove the radio from the instrument panel.