Tail Stop Turn Lamp - Installation

LAMP





1. Check to be certain that the two plastic snap post retainers (3) are in good condition and properly installed in the outer box side panel. If a retainer is removed, it must be replaced with a new retainer.
2. Check to be certain that the two U-nuts are in good condition and properly installed on the inboard side of the rear lamp unit housing.
3. Position the rear lamp unit (5) to the lamp opening of the outer box side panel.
4. Reconnect the two wire harness connectors (2 and 4) to the two bulb sockets on the back and bottom of the lamp housing.
5. Align the two receptacles on the outboard side of the rear lamp housing with the two plastic snap post retainers in the outer box side panel.
6. Using hand pressure, push firmly and evenly on the outboard side of the lamp until both receptacles are fully engaged over the snap post retainers.
7. Starting with the upper screw first, install and tighten the two screws (1) that secure the rear lamp unit to the side jamb of the tailgate opening. Tighten the screws to 2.5 Nm (21 in. lbs.).
8. Reconnect the battery negative cable.