U0146

U0146-LOST COMMUNICATION WITH CENTRAL GATEWAY (TIPM)

For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
Continuously when the ignition is on.

The battery voltage between 10.0 and 16.0 Volts.

Ignition Off Draw (IOD) fuse installed.

Totally Integrated Power Module (TIPM) is configured correctly.

- Set Condition:
Bus messages not received from the Totally Integrated Power Module (TIPM) for approximately two to five seconds.





VERIFY DTC IS ACTIVE

NOTE: Make sure the IOD fuse is installed and the battery is fully charged before proceeding.

1. Turn the ignition on.
2. With the scan tool, read the active DTCs.

Does the scan tool display active: U0146-LOST COMMUNICATION WITH CENTRAL GATEWAY?

Yes

- Totally Integrated Power Module (TIPM) Perform the U0141-Lost Communication with IPM (FCM/TIPM) diagnostic procedure.

No

- Perform the Stored Lost Communication DTCs diagnostic procedure.