Independent Front Suspension

REMOVAL

Special Tools:










1. Raise vehicle and support the vehicle.
2. Remove the tire and wheel.
3. Remove the upper ball joint retaining nut.
4. Separate the upper ball joint (4) from the knuckle (6) using Ball Joint Remover (5).

5. Remove the wheel speed sensor wire from the upper control arm.
6. Move the knuckle out of the way for access to remove the ball joint.
7. Remove the ball joint boot.

NOTE: It may be necessary to install a block of wood between the control arm and frame bracket to allow clearance for the ball joint press tool.






NOTE: Extreme pressure lubrication must be used on the threaded portions of the tool. This will increase the longevity of the tool and insure proper operation during the removal and installation process.

8. Remove the ball joint (4) from the upper control arm (3) using Ball Joint Press (1), Ball Joint Remover (2) and Ball Joint Remover (5).