Electric Locking Differential Carrier - Removal

REMOVAL





1. Remove lubricant fill hole plug from the differential housing cover.
2. Remove differential housing cover and drain the lubricant from housing.
3. Remove axle shafts.
4. Cut sensor wire tie strap (4) from adjuster lock.
5. Remove sensor target magnet (1) from bearing cap.





6. Remove adjuster lock bolts (3) and adjuster locks (2).





7. Remove electric locker connector (1) retainer (2) bolt from differential housing.
8. Remove connector (1) and retainer (2) from differential housing.





9. Remove retainer (1) from connector and remove o-ring (2) from connector.





10. Mark bearing caps (2) left and right for installation reference.
11. Remove bearing cap bolts and remove bearing caps (2).
12. Loosen differential bearing adjusters (3) with a hammer and punch.
13. Slid electric locker connector through differential housing.
14. Remove differential case with bearing cups from the housing.
15. Tag bearing cups left and right for installation reference.