Sunroof - Installation

INSTALLATION

1. Verify that glass panel is loose and slightly retracted.
2. Raise sunroof module assembly and guide it carefully into position.
3. While supporting the sunroof assembly, start the 12 attaching screws, four along each side rail, two along the front trough and two along the motor bracket.
4. Locate the alignment holes along the sides of the module assembly and position the holes so that they line up with the holes located in the roof top support brackets.
5. Install the attaching screws.
6. Connect the electrical connector.
7. Connect the drain tubes to the sunroof.
8. Connect the battery negative cable.
9. Test sunroof operation, adjust if necessary Adjustments.
10. Install the headliner Headliner - Installation.