Compass And Mini-Trip Computer Module - Removal

REMOVAL - LHD

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.





1. Disconnect and isolate the negative battery cable.
2. Remove the Instrument Panel top cover / defroster grille, Instrument Panel Cover - Removal to gain access to the Remote Compass Module (RCM) (2).
3. Disconnect the RCM electrical connector (1).
4. Remove the retaining screws (3) securing the RCM (2) to the IP.
5. Remove the RCM from the vehicle.