Fog Lamp - Removal

LAMP

CHRYSLER





1. Disconnect and isolate the battery negative cable.
2. Reach up behind the lower edge of the front fascia (2) to access and disconnect the front end module wire harness connector from the front fog lamp bulb connector receptacle (3).
3. Using a trim stick or another suitable wide flat-bladed tool, carefully pry between the front fog lamp mounting ring (1) and the back of the front fascia fog lamp seat as necessary to separate the four latch features (4) integral to the back of the fog lamp seat from the slots in the mounting ring.
4. Remove the front fog lamp unit from the fascia.

DODGE





1. Disconnect and isolate the battery negative cable.
2. Reach up behind the lower edge of the front fascia to access and disconnect the front end module wire harness connector from the front fog lamp bulb connector receptacle (3).
3. Remove the two screws (4) that secure the lamp bracket to the back of the fog lamp seat (1) in the front fascia.
4. Disengage the three latch features (2) of the fog lamp bracket from the opening on the back of the seat and push the fog lamp forward far enough so the latch features are clear of the opening.
5. From the face of the front fascia, remove the fog lamp and bracket from the seat as a unit.