Shaft Lock Module - Installation

INSTALLATION





1. If not present, insert the ignition key into the ignition lock cylinder. This will move the shaft lock module locking bolt to the unlocked position. Leave the key in the lock cylinder while the shaft lock module service is being completed.
2. Connect the wiring harness connector to the module.
3. Align the engagement and slide tabs (2) on the shaft lock module housing (1) with the slots and channels in the mounting bracket (3) on the steering column.
4. Carefully slide the module toward the top (steering wheel end) of the column until it is in mounted position and the spring clips on the module have engaged the bracket, locking it in place.





5. Install the steering column cover reinforcement (1) using the four mounting screws (2).
6. Install the instrument panel kneeblocker . Service and Repair

NOTE: Vehicles equipped with PEM: If the WIN is being replaced, a diagnostic scan tool MUST be used to initialize and configure the new PEM. Follow the programming steps outlined in the diagnostic scan tool for Replace found under Miscellaneous Functions for the PEM/Passive Entry Module menu item.

NOTE: If a NEW column lock module has been installed, a new Wireless Ignition Node (WIN) must also be installed.

NOTE: For module replacement and programming guide Programming and Relearning .