Fold Stow Module (FSM)
B210E-BATTERY VOLTAGE HIGH
For a complete wiring diagram, refer to the Wiring Information.
- When Monitored:
Engine running, during seat operation.
- Set Condition:
This code is set immediately after the Folding Seat Module (FSM) receives a high charging system voltage message over the CAN Interior Bus or detects voltage over 16.5 volts on the (A905) B(+) circuit.
Diagnostic Test
1. CHECK PCM FOR CHARGING SYSTEM DTCS
1. With the scan tool, read PCM DTCs.
Are there any Charging System DTCs set in the PCM?
Yes
- Charging System and Testing and Inspection for Charging System diagnostic procedures.
No
- Go To 2
2. TEST FOR INTERMITTENT CONDITION
1. With the scan tool, record and erase DTCs
2. Turn the ignition switch to the OFF position then start the engine and let run for one minute.
3. Attempt to operate the Power Folding Seat.
4. With the scan tool, read DTCs.
Does the scan tool display active this DTC?
Yes
- Go To 3
No
- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
- Perform POWER FOLDING SEAT SYSTEM VERIFICATION TEST. Power Folding Seat System Verification Test.
3. CHECK THE VOLTAGE ON THE (A905) B(+) CIRCUIT
1. Turn the ignition off.
2. Gain access to the Power Folding Seat in-line connector.
3. Start the engine and let idle.
4. Backprobe and measure the voltage on the (A905) B(+) circuit at the in-line harness connector and compare to voltage at the vehicle battery.
Is the voltage at the (A905) B(+) circuit the same as measured at the battery?
Yes
- Test the (A905) B(+) circuit from the in-line connector to the Folding Seat Module C1 connector and repair if necessary, if circuit is OK replace the Folding Seat Module.
- Perform POWER FOLDING SEAT SYSTEM VERIFICATION TEST. Power Folding Seat System Verification Test.
No
- Repair the (A905) B(+) circuit as necessary.
- Perform POWER FOLDING SEAT SYSTEM VERIFICATION TEST. Power Folding Seat System Verification Test.