B2182

B2182-HEATED SEAT MODULE POWER SUPPLY HIGH

For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
With the ignition on, during heated seat operation.

- Set Condition:
The Heated Seat Module (HSM) detects voltage over 16.0 volts.





Diagnostic Test
CHECK PCM FOR CHARGING SYSTEM DTC
1. Turn the ignition on.
2. With the scan tool, clear all DTC's.
3. Cycle the ignition switch from on to off.
4. Start the engine.
5. Run the engine at approximately 1500 RPM for 1 minute.
6. With the scan tool, read DTCs.

Are there any Charging System DTCs set in the PCM?

Yes

- Charging System and Testing and Inspection for Charging System diagnostic procedures.

No

- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
- Perform BODY VERIFICATION TEST. Body Verification Test.