C2205

C2205-STEERING ANGLE SENSOR INTERNAL

For a complete wiring diagram, refer to the Wiring Information.



- When Monitored:
With the ignition on.

- Set Condition:
The Steering Angle Sensor (SAS) has set an internal failure status.





Diagnostic Test
CHECK FOR AN ACTIVE DTC

NOTE: Before proceeding with the diagnostic procedure, verify that the connections are properly made, seated and verify proper pin terminal tension. A loose connection at any of the SCCM connectors may cause the DTC to set.

1. Turn the ignition on.
2. With the scan tool, read DTCs.

Does the scan tool display this DTC as active?

Yes

- Replace the Clockspring/SAS. Clockspring - Removal.
- Perform the ABS VERIFICATION TEST. ABS Verification Test.

No

- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
- Perform the ABS VERIFICATION TEST. ABS Verification Test.