Park Assist Module - Installation

INSTALLATION






1. Position the Park Assist Module (PAM) (1) to the right quarter inner panel (2), to the rear of the C-pillar and above the right rear wheel house.

2. Engage the two lower mounting tabs of the PAM into the stamped pockets in the right quarter inner panel.

3. Reinstall the plastic push-in fastener (4) that secures the upper mounting tab of the PAM to the right quarter inner panel.

4. Reconnect the two body wire harness connectors (3) to the PAM connector receptacles.

5. If equipped, reinstall the Passive Entry (PE) Low Frequency (LF) antenna. .

6. Reinstall the trim onto the right quarter inner panel. Quarter Trim Panel - Installation.

7. Reconnect the negative cable to the battery.