Shaft Cover Seal - Installation

INSTALLATION






1. Place shaft seal and cover (2) over mounting studs on floor pan and securely install fasteners. Make sure cover extends down over top of steering gear housing.





2. Verify the front wheels of vehicle are in the STRAIGHT-AHEAD position.

3. Collapse the intermediate shaft (2). Center it over the steering gear pinion shaft (3), lining up the ends, then slide the intermediate shaft onto the shaft extension.

4. Install the intermediate shaft coupling bolt (1). Tighten the bolt to 42 Nm (31 ft. lbs.).

5. Reposition the floor carpet in place.





6. Remove steering wheel holder.

7. Road test vehicle to ensure proper operation.