Service Procedure
NOTE:wiTECH must be used to perform this recall. This procedure must be performed with software release level 13.02 or higher. If the reprogramming flash for the PCM is aborted or interrupted, repeat the procedure.
A. Reprogram the PCM:
1. Open the hood. Install a battery charger and verify that the charging rate provides 13.0 to 13.5 volts. Do not allow the charger to time out during the flash process. Set the battery charger timer (if so equipped) to continuous charge.
NOTE:
Use an accurate stand-alone voltmeter. The battery charger voltmeter may not be sufficiently accurate. Voltages outside of the specified range will cause an unsuccessful flash. If voltage reading is too high, apply an electrical load by activating the park or headlamps and/or HVAC blower motor to lower the voltage.
2. Connect the wiTECH VCI pod to the vehicle data link connector located to the right of the park brake pedal.
3. Place the ignition in the "RUN" position.
4. Open the wiTECH Diagnostic application.
5. Starting at the "Select Tool" screen, highlight the row/tool for the wiPOD device you are using. Then select "Next" at bottom right side of the screen.
6. Enter your "User id" and "Password", then select "Finish" at the bottom of the screen.
7. From the "Vehicle View" screen, click on the PCM icon.
8. From the "PCM View" screen, compare the "Current ECU Flash Number" with the "New Part Number" listed on the "sort table". If the "Current ECU Flash Number" is the same as the "New Part Number" continue to Step 19. If the part numbers are not the same, continue to Step 9.
9. With the cursor over the desired flash file, click the small green arrow button on the right side of the screen.
10. From the "ECU Flash" screen follow the wiTECH screen instructions to complete the flash.
11. Once the flash is complete click the "OK" button on the "ECU Flash" screen.
12. Select the "Clear Stored DTCs" button.
13. From the "PCM View" screen, compare the "Current ECU Flash Number" with the "New Part Number" listed on the "sort table". If the "Current ECU Flash Number" is the same as the "New Part Number" the flash is complete. If the part numbers are not the same, repeat Steps 7 through 13.
14. Select the "Misc. Functions" tab in the PCM View screen.
15. Highlight "Clear Learned Variable Line Pressure (VLP) Counters" and select the green arrow to start the procedure.
16. Follow the screen prompts to complete the procedure.
17. From the Misc. Functions tab screen, highlight "Quick Learn (62TE)" and select the green arrow to start the procedure.
18. Follow the screen prompts to complete the procedure.
19. Clear all stored DTCs.
20. Turn the ignition to the "OFF" position and remove the wiPOD and battery charger from the vehicle.
21. Continue with Section B. Install Authorized Modifications Label.
B. Install the Authorized Modifications Label:
1. Type or print (with a ballpoint pen) the recall number, repair modification, dealer code and date Reprogram PCM on the Authorized Modifications Label (Figure 1).
2. Attach the label near the VECI label and then close the hood.
3. Complete Proof of Correction Form for California Residents.
NOTE:
This recall is subject to the State of California Registration Renewal/Emissions Recall Enforcement Program. Complete a Vehicle Emission Recall Proof of Correction Form (Form No. 81-016-1053) and supply it to vehicle owners residing in the state of California. The correction form will provide proof that this recall has been performed when the owner renew the vehicle registration.