Electronic Power Steering Module (EPS)

U1415-00-IMPLAUSIBLE/MISSING VEHICLE CONFIGURATION DATA

For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
Continuously with the ignition on.

- Set Condition:
The Electronic Power Steering (EPS) Module receives incorrect vehicle configuration information from the Body Control Module (BCM).





Diagnostic Test

1. VERIFY THE DTC IS ACTIVE
1. Turn the ignition on.
2. With the scan tool, read DTCs.

Is the DTC active at this time?

Yes

- Go To 2

No

- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
- Perform the EPS VERIFICATION TEST. EPS Verification Test.

2. CAN BUS DTCS SET IN BODY CONTROL MODULE (BCM)

NOTE: Verify that the BCM has the correct vehicle configuration before proceeding with this test step.

1. With the scan tool, read DTCs in the BCM.

Are there any active CAN Bus DTCs present?

Yes

- Testing and Inspection and perform the appropriate diagnostic procedure.

No

- Replace the EPS Module. Steering Gear - Removal.
- Perform the EPS VERIFICATION TEST. EPS Verification Test.