Radio Frequency Module (RF Hub) - Installation

INSTALLATION

The Remote Frequency Hub Module (RF Hub) assembly consists of a harness connector and two pushpin.

The control module is located behind the rear cab panel beneath the rear sliding glass assembly. The remote start antenna is plugged directly into the RH Hub






1. Disconnect and isolate the negative battery cable.

2. Position into place and install the RF Hub (1) and retainers (3).

3. Connect the electrical connectors to the RF Hub (2).

4. If equipped, connect the remote start coax cable electrical connector to the RF hub.

5. Install left side rear cab trim panels and install the panel push pins. Cab Back Trim Panel - Installation

6. Install left rear child seat tether. Child Seat Anchor - Installation

7. Install left rear seat.

8. Install the left rear seat rear inboard bolt with seat belt buckle.

9. Flip the left rear seat cushion down.

10. Connect the negative battery terminal to the negative battery post.

11. Perform RF Hub replacement procedure with the scan tool.