Instrument Panel - Installation

INSTALLATION

1. With the help of an assistant, position the instrument panel (5) into the vehicle and install the right side guide pin and the left side guide hook to the sides of the cowl panel.

2. Connect the ORC Module electrical connector and position the wiring under the carpet.

3. Install the ground eyelet fastener at ORC/YAWL Modules and position the carpet back as necessary.





4. Install the fence line bolts on top of I/P.

5. Tighten the bolts to 12 Nm (9 ft. lbs.).

6. Install the fence line bolt access covers.





7. Install the three bolts (1) that secure the right side instrument panel bracket to the cowl panel.

8. Tighten the bolts to 12 Nm (9 ft. lbs.).





9. Connect the coaxial cable connectors (2) to the antenna coaxial cable connectors (1) located on the right side of the cowl panel.





10. Connect the five instrument panel wire harness connectors to the two body wire harness connectors (1) located on the right side of the cowl panel (2).





11. Install the right cowl trim panel Cowl Trim Panel - Installation.

12. Install the glove box to the instrument panel Instrument Panel Glove Box - Installation.





13.

NOTE: Left side shown, right side typical.

Connect the headliner wire harness connector (2) located at the A-pillar and secure the harness push pin (1) fully.

14. Install the right side hush panel.






NOTE:
Left side shown right side similar.

15. Install the right instrument panel side cover.





16. Install the right A-pillar trim A-Pillar Trim Panel - Installation.





17. Install the two bolts (1) that secure the instrument panel to the center of the floor panel.

18. Tighten the bolts to 12 Nm (9 ft. lbs.).

19. Install the brake sled to I/P bolts.





20. Install the floor console, if equipped Floor Console - Installation.





21. Install the three bolts that secure the left side of the instrument panel to the dash panel.

22. Tighten the bolts to 12 Nm (9 ft. lbs.)





23. Connect the headliner wire harness connector (2) located at the A-pillar and secure the harness push pin (1) fully.

24.




Install the left instrument panel side cover fully engaging the retainer clips.





25. Install the left A-pillar trim A-Pillar Trim Panel - Installation.

26. Install the steering column as necessary Steering Column - Installation.





27. Install the manual park release lever (2) and install the bolts (1).





28. Install the trim panel (1) covering the manual park release lever to the instrument panel and seat fully.
29. Install the hood release lever. Hood Release Cable - Installation





30. Connect the park brake release lever link (2).





31. Connect the instrument panel wire harness connector (2) located above the brake pedal to the bulkhead wire harness connector (1).

32. Install the steering column opening cover. Steering Column Opening Cover - Installation





33. Install the left cowl trim panel Cowl Trim Panel - Installation.

34. Install the front seat assembly, .

35. Reconnect the negative battery cable.