Occupant Restraint Controller Bracket - Installation

BRACKET

WARNING:
To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.





1. Position the adapter bracket (1) onto the mount (4) welded onto the top of the floor panel transmission tunnel.

2. Install and tighten the nut (3) that secures the bracket to the stud on the mount. Tighten the nut to 12 Nm (9 ft. lbs.).

3. Install and tighten the screw (2) that secures the bracket to the mount. Tighten the screw to 10 Nm (4 ft. lbs.).

4. Reinstall the Occupant Restraint Controller (ORC) into the vehicle. .