Assembly

ASSEMBLY

Special Tools:















NOTE: If clutch discs are being replaced, soak in 8HP trans fluid before assembly.






1. Insert the piston and the retaining ring (1) into the housing.





2. Position the oil pump housing assembly (4) in a suitable arbor press.

3. Using (8285) (1), press on the fingers of the piston retaining ring to remove tension, and install the two halves of the split retainer ring (2).





4. Install the hub (3).

5. Install the clutches and spacers (4).

6. Install the snap ring (2).

7. Install the outer ring (1) (below B-piston).





8. Position the B-piston alignment tab (2) above the notch and install B-piston (1) on the assembly.