Driver Door Module (DDM, DMFL/R)

B1F02-11-MIRROR VERTICAL MOTOR CONTROL-CIRCUIT SHORT TO GROUND

For a complete wiring diagram, refer to the Wiring Information.





Theory of Operation

The Mirror Vertical Driver circuit supplies battery voltage for the mirror up position and ground for the mirror down position. The Mirror Common Driver supplies battery voltage for the mirror Down position and ground for the mirror up position.

- When Monitored:
Continuously.

- Set Condition:
The Door Module senses a short low on the Mirror Vertical Driver circuit for more than 10 ms.





Diagnostic Test

1. TEST FOR INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, record and erase Diagnostic Trouble Codes (DTCs).
3. Press and release the Mirror Select switch to select the Driver Outside Rearview Mirror.
4. Operate the Mirror Adjust switch in all directions several times while monitoring the scan tool for DTCs. NOTE: After adjusting the mirror in one direction wait at least two seconds before adjusting the mirror in the opposite direction, as this will allow time for an active fault to set if present.

Does the scan tool display; B1F02-11-MIRROR VERTICAL MOTOR CONTROL - CIRCUIT SHORT TO GROUND?

Yes

- Go To 2

No

- The conditions that caused this code to set are not present at this time. For vehicle's equipped with folding outside rearview mirrors, repeat test with mirror folded. If DTC is now active, Go To 2. Otherwise, use the wiring diagram/schematic as a guide and inspect the wiring and connectors.
- Perform the BODY VERIFICATION TEST. Body Verification Test .

2. INSPECT MIRROR CONNECTIONS
1. Turn the ignition off.
2. Disconnect the Driver Outside Rearview Mirror C2 connector at the Drivers Door Module.
3. Inspect the wiring harness, connectors and the Drivers Door Module.

Were there any problems found?

Yes

- Repair as necessary.
- Perform the BODY VERIFICATION TEST. Body Verification Test

No

- Go To 3

3. MIRROR OR MODULE
1. Turn the ignition on.
2. With the scan tool, record and erase DTCs.
3. Press and release the Mirror Select switch to select the Driver Outside Rearview Mirror.
4. Operate the Mirror Adjust switch in all directions several times while monitoring the scan tool for DTCs. NOTE: After adjusting the mirror in one direction wait at least two seconds before adjusting the mirror in the opposite direction, as this will allow time for an active fault to set if present.

5. With the scan tool, read DTCs. NOTE: Check for a change in DTCs.

Does the scan tool display: B1F02-13-MIRROR VERTICAL MOTOR CONTROL - CIRCUIT OPEN as active?

Yes

- With the circuit now OPEN that indicates the short is NOT in the Module. Replace the mirror. Service and Repair
- Perform the BODY VERIFICATION TEST. Body Verification Test

No

- Replace the Door Module. Door Module - Removal
- Perform the BODY VERIFICATION TEST. Body Verification Test .