Generator - Installation

5.7L

1. Position the generator to the engine and install the two mounting bolts. Tighten to 41 Nm (30 ft. lbs.).

2. Position the support bracket to the front of the generator and install the bolt and nuts. Tighten to 41 Nm (30 ft. lbs.).

3. Snap the field wire connector into the rear of the generator.

4. Install the B+ terminal eyelet to the generator output stud. Tighten mounting nut to 12 Nm (8.8 ft. lbs.).

CAUTION:
Never force a belt over a pulley rim using a screwdriver. The synthetic fiber of the belt can be damaged.

CAUTION:
When installing a serpentine accessory drive belt, the belt must be routed correctly. The water pump may be rotating in the wrong direction if the belt is installed incorrectly, causing the engine to overheat. Refer to belt routing label in engine compartment, or Refer to the Belt Schematics in 7, Cooling System.

5. Install the generator drive belt Serpentine Accessory Drive Belt - Installation.

6. Connect the negative battery cable.