Air Suspension Control Module (ASCM)
U0402-00-IMPLAUSIBLE DATA RECEIVED FROM TCM
For a complete wiring diagram, refer to the Wiring Information.
- When Monitored:
Continuously with the ignition on, one valid CAN message received at least once, and no U0002-88-CAN C Bus Off Performance DTC present.
- Set Condition:
When the Air Suspension Control Module (ASCM) detects an incorrect CAN message from the Transmission Control Module (TCM).
Diagnostic Test
1. VERIFY THE DTC IS ACTIVE
NOTE: This DTC must be active for the results of this test to be valid.
1. Turn the ignition on.
2. With the scan tool, record and erase DTCs.
3. Cycle the ignition switch from off to on.
4. With the scan tool, read DTCs.
Is the DTC active at this time?
Yes
- Go To 2
No
- Go To 4
2. CHECK IF BODY CONTROL MODULE (BCM) CAN BUS DTCS ARE PRESENT
1. With the scan tool, read the BCM DTCs.
Are there any BCM CAN BUS DTCs present?
Yes
- Perform the appropriate diagnostic procedure. Testing and Inspection.
- Perform the ASCM VERIFICATION TEST. ASCM Verification Test.
No
- Go To 3
3. CHECK IF TRANSMISSION DTCS ARE PRESENT
1. With the scan tool, read Transmission DTCs.
Are there any Transmission DTCs present?
Yes
- Perform the appropriate diagnostic procedure. Testing and Inspection.
No
- Using the schematics as a guide, check the ASCM pins, terminals, and connectors for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the Air Suspension Control Module (ASCM). Air Suspension Control Module - Removal.
- Perform the ASCM VERIFICATION TEST. ASCM Verification Test.
4. INTERMITTENT WIRING AND CONNECTORS
1. Using the wiring diagram/schematic as a guide, inspect the wiring harness and connectors.
2. Wiggle test the wiring harness and connectors while monitoring the scan tool data relative to this circuit.
3. Look for the data to change or for the DTC to reset during the wiggle test.
4. While monitoring the scan tool data relative to this circuit, move the selector switch to each position several times.
5. Look for the data to change other than as expected or for the DTC to reset.
Were any problems found?
Yes
- Repair as necessary.
- Perform the ASCM VERIFICATION TEST. ASCM Verification Test.
No
- Test complete, the condition or conditions that originally set this DTC are not present at this time.