Remote Start Antenna - Installation

INSTALLATION





The Remote Start Antenna Module Assembly consists of an electrical connection to the Remote Frequency Hub(1), a length of coax cable (2), two mounting clips (3) and (4), and a control module/antenna (5).

The control module is located behind the rear cab panel. The module electrical connector plugs into the RF Hub which is also located in the rear cab panel.

1. Disconnect and isolate negative battery cable.

2. Install remote module assembly and connect the harness.

3. Connect the coax cable electrical connector at the RF hub

4. Install left side rear cab trim panels and install panel push pins back in place.

5. Install left rear child seat tether.

6. Install left rear seat.

7. Install left rear seat front mounting bolts

8. Installl the left rear seat rear inboard bolt with seat belt buckle.

9. Flip the left rear seat cushion back down.