Radio Frequency Module (RF Hub) - Removal

REMOVAL

The Remote Frequency Hub (RF Hub) Module Assembly consists of a harness connector and two pushpin.

The control module is located behind the rear cab panel beneath the rear sliding glass assembly. Note that the remote start antenna is plugged directly into the RF Hub.






1. Disconnect and isolate negative battery cable.

2. Flip the left rear seat cushion.

3. Remove the left rear seat rear inboard bolt with seat belt buckle.

4. Remove left rear seat.

5. Remove left rear child seat tether. Child Seat Anchor - Removal

6. Remove rear left side rear cab trim panel push pins to remove panel. Cab Back Trim Panel - Removal

7. Disconnect coax cable electrical connector at the RF hub (1).

8. Disconnect harness (2) and remove the RF Hub retainers. (3)