A/C And Heater Control Module - Installation

INSTALLATION

1. Connect the wire harness connector to the A/C heater module.

2. Position the A/C heater module to the instrument panel, through the glove box opening and engage the module retaining screws to the slots on instrument panel.





3. Tighten the two screws (1) that secure the A/C heater module (2) to the instrument panel to 2 Nm (17 in. lbs.).

4. Install the glove box Instrument Panel Glove Box - Installation.

5. Install the right side instrument panel end cap.

6. Connect the negative battery cable.

7. Initiate the Actuator Calibration function using a scan tool .