Park Assist Module - Installation

INSTALLATION

WARNING:
To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.





1. Position the Park Assist Module (PAM) (1) to the left cowl side inner panel.

2. Align and insert the two rearward mounting tabs of the PAM into the two slots in the cowl side inner panel.
3. Reinstall the plastic push-in fastener (2) that secures the forward mounting tab of the PAM to the cowl side inner panel.

4. Reconnect the two body wire harness connectors (3) to the PAM connector receptacles.

5. Reinstall the trim onto the cowl side inner panel. Cowl Trim Panel - Installation.

6. Reconnect the negative cable to the battery.