B1634

B1634-LEFT HI BEAM CONTROL CIRCUIT HIGH

For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
Continuously.

- Set Condition:
When the Totally Integrated Power Module (TIPM) detects a high condition.





Diagnostic Test

1. INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, clear all DTCs.
3. Turn the High Beam Headlamps on.
4. With the scan tool, read DTCs.

Does the scan tool display DTC: B1634-LEFT HI BEAM CONTROL CIRCUIT HIGH?

Yes

- Go To 2

No

- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

2. CHECK THE (L33) LEFT HIGH BEAM CONTROL CIRCUIT FOR A SHORT TO VOLTAGE IN THE HARNESS
1. Turn the Headlamps off.
2. Turn the ignition off.
3. Disconnect the Left Front Lamp Assembly C4 harness connector.
4. Disconnect the TIPM C3 harness connector.
5. Turn the ignition on.
6. Measure the voltage between ground and the (L33) Left High Beam Control circuit.

Is there any voltage present?

Yes

- Repair the short to voltage in the (L33) Left High Beam Control circuit.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Go To 3

3. CHECK THE TIPM FOR CORRECT OPERATION
1. Turn the ignition off.
2. Reconnect the TIPM C3 harness connector.
3. Connect a 12-volt test light between the (L33) Left High Beam Control circuit and (L911) Headlamp Return Signal circuit in the Left Front Lamp Assembly C4 harness connector.
4. Turn the ignition on.
5. Turn the High Beam Headlamps on.

Does the test light illuminate brightly?

Yes

- Replace the Left High Beam Bulb.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Go To 4

4. CHECK THE (L33) LEFT HIGH BEAM CONTROL CIRCUIT FOR AN OPEN IN THE HARNESS
1. Turn the ignition off.
2. Disconnect the TIPM C3 harness connector.
3. Measure the resistance of the (L33) Left High Beam Control circuit between the Left Front Lamp Assembly C4 harness connector and the TIPM C3 harness connector.

Is the resistance below 5.0 Ohms?

Yes

- Go To 5

No

- Repair the open in the (L33) Left High Beam Control circuit.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

5. CHECK THE (L911) HEADLAMP RETURN SIGNAL CIRCUIT FOR AN OPEN IN THE HARNESS
1. Measure the resistance of the (L911) Headlamp Return Signal circuit between the Left Front Lamp Assembly C4 harness connector and the TIPM C3 harness connector.

Is the resistance below 5.0 Ohms?

Yes

- Replace the Totally Integrated Power Module (TIPM).
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Repair the open in the (L911) Headlamp Return Signal circuit.
- Perform the BODY VERIFICATION TEST. Body Verification Test.