Power Sliding Door Module, Left (PSDML)

U1144-LOST COMMUNICATION WITH POWER SLIDING DOOR MODULE-RIGHT





For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
Continuously when the ignition is on.

Battery voltage between 10 and 16 volts.

Ignition Off Draw (IOD) fused installed.

Totally Integrated Power Module (TIPM) is configured correctly.

- Set Condition:
Bus messages not received from the Right Power Sliding Door Module for approximately two to five seconds.





Diagnostic Test
VERIFY THE DIAGNOSTIC TROUBLE CODE (DTC) IS ACTIVE

NOTE: Make sure the IOD fuse is installed and the battery is fully charged before proceeding.

1. Turn the ignition on.
2. With the scan tool, read active DTCs.

Is this DTC active?

Yes

- Totally Integrated Power Module (TIPM) and perform the U1144-Lost Communication with Power Sliding Door Module - Right diagnostic procedure.

No

- Perform the Stored Lost Communication DTCs diagnostic procedure. Stored Lost Communication DTCs.