Second Row

INSTALLATION






1. Assemble the rear heated switch (3) into the switch bezel (4) by pressing the two together until the retaining tabs snap securely into place. Make sure that the switch retaining tabs are fully engaged to the bezel.

2. Connect the wire harness connector (5).

3. Install the switch and bezel assembly into the sliding door trim panel (6). Press the switch into the trim panel opening until the retaining tabs snap securely into place. Make sure that the switch bezel retaining tabs are fully engaged to the door trim panel.

4. Reconnect the negative battery cable.

5. Verify proper heated seat system operation.