Compass And Mini-Trip Computer Module - Installation

INSTALLATION - LHD

WARNING:
To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.





1. Position the Remote Compass Module (RCM) (2) onto the top of the Instrument Panel (IP).

2. Install the RCM retaining screws (3).

3. Connect the electrical connector (1).

4. Install the instrument panel top cover / defroster grille, Instrument Panel Cover - Installation.

5. Connect the negative battery cable.

NOTE:
If the RCM has been replaced for any reason the Manual Compass Calibration and Compass Variance procedures will need to be performed, Adjustments for the appropriate procedure.

6. Verify the compass operation.