Headlamp Leveling Switch - Installation - Export

INSTALLATION

WARNING:
To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.

NOTE:
The following procedure applies only to the Right-Hand Drive (RHD) headlamp leveling switch. On Left-Hand Drive models equipped with remote manual headlamp leveling, the switch is integral to the dimmer module. Dimmer Switch - Installation .





1. Position the headlamp leveling switch (3) to the switch opening from the face of the headlamp switch bezel.

2. Using hand pressure, push the switch through the opening in the bezel until the metal spring clip (2) on each side of the switch housing snaps into place on the back of the bezel.

3. Reconnect the instrument panel wire harness connector (1) to the switch connector receptacle.





4. Align the snap clips on the back of the headlamp switch bezel with the receptacles in the instrument panel base trim. Using hand pressure, press firmly and evenly on the bezel until the clips snap into place.

5. Reconnect the battery negative cable.