Remote Radio Switches - Installation

INSTALLATION





1. Connect the remote radio electrical connector.
2. Install the switch into the steering wheel until it clips securely in place (2).
3. Position the spoke bezel assembly close enough to the steering wheel and connect the electrical connector.
4. Engage the lip on the inboard side of the bezel under the edge of the driver airbag trim cover.
5. Position the spoke bezel, mounting adapter plate and pod as a unit to the steering wheel. Be certain that the steering wheel wire harness is not pinched.
6. From the back of the steering wheel (1), install and tighten the screw (3) that secures the bezel assembly to the steering wheel spoke.
7. Connect the negative battery cable.