C0011

C0011-01-LEFT FRONT OUTLET VALVE - GENERAL ELECTRICAL FAILURE

For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
With the ignition on and no system under voltage condition present.

- Set Condition:
The Anti-lock Brake System (ABS) Module is unable to activate the correct solenoid valve.





1. VERIFY THE DTC IS ACTIVE

NOTE: This DTC must be active for the results of this test to be valid.

1. Turn the ignition on.
2. With the scan tool, read and record DTCs.
3. With the scan tool, read and record Freeze Fame information.
4. With the scan tool, erase DTCs.
5. Start the engine.
6. Press the brake pedal firmly and release.
7. With the scan tool, read and record DTCs.

Is the DTC active at this time?

Yes

- Go To 2

No

- Perform the ABS INTERMITTENT CONDITION TEST. ABS Intermittent Condition Test.

2. ANTI-LOCK BRAKE SYSTEM (ABS)
1. Perform any Technical Service Bulletins (TSBs) that may apply.
2. Turn the ignition off to the lock position.
3. Inspect the related wiring harness. Look for any chafed, pierced, pinched, or partially broken wires.
4. Inspect the related wire harness connectors. Look for broken, bent, pushed out, or corroded terminals.

Were any problems found?

Yes

- Repair as necessary.
- Perform the ABS VERIFICATION TEST. ABS Verification Test.

No

- NOTE: For this failure it is necessary to replace both the ABS Module and the HCU as a complete unit.
- Replace the Anti-lock Brake System (ABS) Module. Anti-Lock Brake System Module - Removal.
- Replace the Hydraulic Control Unit (HCU). Hydraulic Control unit (HCU) - Removal.
- Perform the ABS VERIFICATION TEST. ABS Verification Test.