P1D7F

P1D7F-ETC SELF-LEARNING FAILURE

For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
With the ignition on.

- Set Condition:
The Throttle Body Self Learn procedure was not able to run because the Intake Air temperature and Engine Coolant temperature are either too high or too low, the vehicle is moving, or the engine is started.





Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Pre-Diagnostic Troubleshooting Procedure.
DTC IS ACTIVE

NOTE: Diagnose any TP Sensor, Crankshaft Position Sensor, Camshaft Position Sensor, Engine Coolant Temperature Sensor, Ambient Air Temperature Sensor, or Vehicle Speed Sensor DTCs before continuing.

1. Ignition on, engine not running.
2. With the scan tool, clear DTCs in the PCM.
3. Cycle the ignition key off and on several times, leaving the ignition on for at least 10.0 seconds at a time.
4. With the scan tool, perform the Throttle Body Self Learning routine.

Did the DTC return?

Yes

- If no other DTCs are present, replace the Powertrain Control Module (PCM). PCM/ECM Reprogramming.
- Perform the POWERTRAIN VERIFICATION TEST. Powertrain Verification Test.

No

- Perform the INTERMITTENT CONDITION diagnostic procedure. Intermittent Condition Test.