Roof Joint Molding - Removal

REMOVAL






NOTE: Sunroof models similar.

NOTE: The roof ditch molding is set with body side molding tape. The temperature in the work area and the vehicle should be at least 21° C (70° F) to avoid damaging the roof ditch moldings.

1. Warm the affected stick-on molding and body metal to approximately 32° C (90° F) using a suitable heat lamp or heat gun.
2. starting at one side, pull upward on the roof ditch molding (1) from the painted surface.
3. Remove adhesive tape residue from painted surface of vehicle. Use a 3M Scotch-Brite(TM) Molding Adhesive and Stripe Removal Discs, or equivalent, to clean adhesive residue from painted surfaces. The adhesive removal discs are available from automotive paint suppliers. Refer to instructions supplied with the discs for proper usage.