Heated Seat Relay - Removal

REMOVAL

WARNING: Disable the airbag system before attempting any front seat diagnosis or service. Disconnect and isolate the negative battery (ground) cable and wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.





1. Disconnect and isolate the negative battery cable.
2. Open the cover (1) on the relay receptacle (3), located underneath the front seat (4) being serviced.
3. Remove the heated seat relay (2) from the relay receptacle.