Floor Distribution Duct - Removal

REMOVAL

WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.

NOTE: Right side shown. Left side similar.





1. Remove the shifter housing trim panels to gain access to the floor ducts Instrument Panel Cover - Removal.

NOTE: If the foam seal on a floor duct is deformed or damaged, the seal must be replaced.

2. Remove the two screws (1) that secure each floor duct (2) to the HVAC housing (3) and remove the ducts, as necessary.