Side Marker Lamp Bulb - Installation

BULB

CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket or the lamp wiring.





1. Align the base of the bulb with the side marker lamp bulb socket.
2. Push the bulb straight into the socket until the base is firmly seated.
3. Be certain that a rubber O-ring seal is properly installed and in good condition around the base of the bulb socket.
4. Align the socket and bulb with the keyed opening on the back of the side marker lamp lens/housing.
5. Insert the socket and bulb into the housing until the socket is firmly seated.
6. Rotate the socket clockwise about 30 degrees to lock it into place.
7. Reconnect the wire harness connector (1) to the side marker lamp bulb socket.
8. Reinstall the removed fasteners that secure the front of the front wheel house splash shield to the front fascia, or the rear of the rear wheel house splash shield to the rear fascia. Splash Shield - Installation.
9. Reconnect the battery negative cable.