Tail Stop Turn Lamp Bulb - Removal

BULB






NOTE: Each rear lamp unit contains either three or four bulbs. Vehicles manufactured for markets where rear fog lamps are not required have three bulbs, which are: backup, park/stop and turn signal. The rear lamp units for vehicles manufactured for markets where rear fog lamps are required have four bulbs, which are: dedicated backup in the right rear lamp unit only, dedicated park in each rear lamp unit, dedicated rear fog in the left rear lamp unit only, dedicated stop in each rear lamp unit and dedicated turn signal in each rear lamp unit. The service procedures for each bulb are the same, only the bulb sizes and types may differ.

1. Disconnect and isolate the battery negative cable.
2. Remove the rear lamp unit from the end of the quarter panel. Tail Stop Turn Lamp - Removal.
3. Remove the four screws that secure the socket plate to the back of the lamp housing.





4. Pull the socket plate (1) straight out from the back of the lamp housing (3).
5. Firmly grasp the bulb (2) and pull the base of the bulb straight out of the socket plate.