Operation CHARM: Car repair manuals for everyone.

Sunroof Switch - Installation






INSTALLATION

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.





1. Position the power sunroof switch (2) onto the back of the switch bezel (3).
2. Install and tighten the two screws (1 and 4) that secure the switch mounting tabs to the bezel. Tighten the screws securely.
3. Reinstall the switch and bezel unit onto the headliner. Overhead Console - Installation.
4. Reconnect the battery negative cable.