Windshield Washer Reservoir - Installation

INSTALLATION





1. Position the washer reservoir into the right front fender wheel house.
2. Align the reservoir filler neck with the opening into the engine compartment, the raise the washer reservoir far enough to align the integral mounting tabs with the mounting holes in the inner fender shield.
3. Install and tighten the two screws (3) that secure the reservoir to the inner fender shield. Tighten the screws to 8 Nm (71 in. lbs.).
4. Engage the front and rear washer hoses into the troughs integral to the outboard side of the reservoir.

NOTE: Be certain to reconnect the front and rear washer hoses to the proper outlet nipples of the washer pump (rear washer hose goes to black nipple, front washer hose goes to white nipple). Failure to properly connect the hoses will cause the front and rear washer systems to operate incorrectly.

5. Reconnect the front and rear washer hoses (2) to the barbed outlet nipples of the washer pump. Be certain that the rear washer hose on the left side of the reservoir is connected to the black nipple and the front washer hose on the right side of the reservoir is connected to the white nipple.
6. Reconnect the engine compartment wire harness connector (1) for the washer pump/motor unit to the connector receptacle on the top of the motor.
7. Reinstall the right front wheel house splash shield onto the vehicle. Splash Shield - Installation.
8. Lower the vehicle.
9. Reconnect the battery negative cable.
10. Refill the washer reservoir with the washer fluid drained from the reservoir during the removal procedure.